Yamaha AW2816 Owner's Manual page 75

Operating multiple faders
together (Fader Groups)
"Fader grouping" is a function that lets you operate
the faders of multiple channels as a group. Channels
that are registered in the same fader group can be
controlled together by operating just one of the faders.
1
Press the [EQ] key
The EQ screen FaderGrp page will appear. In this
page you can assign input channels 1–8/monitor
channels 1–16 to fader groups A–D. The row
where the cursor is located is the currently
selected fader group.
2
Use the CURSOR [
fader group A–D.
3
Use the keys of the MIXING LAYER section
to select a mixing layer, and use the [SEL]
keys to select the channels that you want
to assign to that fader group.
When a channel is assigned to a fader group, a
" " symbol will be displayed in the A–D rows.
To cancel an assignment, press the same [SEL]
key once again.
Tip!
While this page is displayed, the lit/dark status of the
[SEL] keys will indicate whether each channel is
assigned to the fader group.
4
Repeat steps 2–3 to make assignments for
the other fader groups.
5
Make sure that the A–D ENABLE buttons
are on (highlighted).
The A–D ENABLE buttons switch the correspond-
ing fader group on/off. To turn a button on, move
the cursor to that button and press the [ENTER]
key.
[F3] key.
]/[ ] keys to select a
Operation section
6
Operate the fader of a channel assigned to
a fader group.
The faders of all channels belonging to that fader
group will move.
Tip!
• If you want to adjust the position of a channel fader
after that channel has already been assigned to a
fader group, turn the ENABLE button off to tempo-
rarily defeat that fader group.
• When screens other than the FaderGrp page are dis-
played, you can press and hold a [SEL] key to tempo-
rarily exclude that channel from the fader group. By
holding down the [SEL] key of a channel and operat-
ing its fader, you can operate the desired channel
independently of its fader group.
3
67