Mounting On The Camera - Panasonic AW-LZ16MD73P Operating Instructions Manual

1/2-inch motor drive lens

Parts and Their Functions

Mounting on the camera

Prior to installation of the lens, turn off the power of the camera.

1 Take the rear lens cap off.

2 Rotate the mount clamp ring on the camera

fully counterclockwise as viewed from front of

the lens.

3 Fit the mounting surface of the lens with that

of the camera aligning the pin on the lens with

the slot in the camera.

Iris gain adjusting trimmer

There is no need for adjustment usually. If

any errors occur due to any reasons,

however, adjustment can be done without

removing the cover.

The iris gain adjusting trimmer becomes

visible inside by removing the rubber cap on

one side of the drive unit. Operate the

trimmer with a small screwdriver.

Rotate the trimmer clockwise for higher gain

and counterclockwise for lower gain. When

increasing the gain, care should be taken not

to cause hunting.

Mount clamp ring

4 Rotate the mount clamp ring fully clockwise.

5 Connect the "Cable to camera" to the

connector, provided for the lens with, on the

camera.

6 Connect the "Cable for control" to the

connector on a pan-tilt head.

For remote control, use an extension cable

(option) to link the lens with a pan-tilt head.

- 5 -

Camera

Table of Contents