Bosch Pack201HS Instruction Manual page 81

Pack201 | Operator Interface | Section 4
PARAMETER
Side Chain Offset
Side Chain Pitches
Side Chains Enable
Speed Eye Acceleration Gain
Speed Eye Deceleration Gain
Speed Eye Off Delay (mm)
Speed Eye On Delay (mm)
Speed Ref� At 10V
Splice # To Reject (prod)
Splice Reject Enable
Splicer Enable
Splicer Offset
Splicer Reject Shifts
Splicer Shifts
Static Seal Enable
Stop Delay Angle deg)
Stop Rate
Sweep Base Rate
Sweep Offset
Sweep Pitches
Sweep Profile Begin/End
Sweep Ratio
© Bosch Packaging Technology, Inc.
All rights reserved 2012
DEFINITION
This is a correction that may be added to change the position of the side
chain pushers�
This is the number of pitches between every two side chain pushers�
In the ON position the side chain option is active� In the OFF position
the option is disabled�
This is the time required for the wrapper to go from a stopped position
to 600 packages per minute�
This is the time required for the wrapper to go from 600 packages per
minute to a stopped position�
This is a delay added to prevent the wrapper from going to low speed as
soon as the Speed eye is unblocked�
This is a delay added to prevent the wrapper from going to run speed as
soon as the Speed eye is blocked�
This is the wrapper speed that will equal 10 volts DC sent out to exter-
nal equipment�
This is the desired number of packages to reject when a splice is pro-
duced�
In the ON position the splice reject eye is active� In the OFF position the
reject eye is disabled�
In the ON position the splicer option is active� In the OFF position the
option is disabled�
This is a correction that may be added to change the position of the
splice�
This is the number of cycles (packages)from the splicer to the reject
device�
This is the number of cycles (packages) from the splicer eye to the
splicer rollers�
In the ON position the static seal option is active� In the OFF position
the option is disabled�
This is the position in a cycle where the machine starts to decelerate
after the stop button is pushed�
This is the desired wrapper speed in packages per minute for the wrap-
per to come to a position stop�
This sets the base speed of the overhead sweep� A value of 100% means
that the sweep would run at a steady speed�
This is a value that can be added to change the placement of the prod-
uct in the infeed conveyor flight.
This is the number of inches between overhead sweep chain pushers
times 2�
This is the point during a machine cycle at which the overhead sweep
starts to speed up� The sweep will return to base rate at the same value
short of the end of the cycle�
This is the ratio of the LPF secondary chain flights to the wrapper infeed
chain flights.
EN | 50