Maintenance And Service; Environment Protection; Troubleshooting - Causes And Corrective Measures - Bosch GTC 400 C Operating/Safety Instructions Manual

Check the tool each time
before use. In case of visible
damage or loose components inside the
measuring tool, safe function can no longer be
ensured.
Keep the tool clean at all times.
Do not immerse the tool into water or
other fluids.
Do attempt to remove dust from the sensor,
camera or reception lens using pointing
objects, and do not wipe over the camera and
reception lens (risk of scratching).
If the tool should fail despite the care taken in
manufacturing and testing procedures, repair
should be carried out by an authorized after-
sales service center for Bosch power tools. Do
Troubleshooting – Causes and Corrective Measures
In the event of a fault, the tool will restart and can then continue to be used. If the fault
persists, the following overview may help you.
Error
Measuring tool cannot be switched on.
Measuring tool cannot be connected to a
computer.

Maintenance and Service

not open the measuring tool yourself.
In all correspondence and spare parts orders,
please always include the 10-digit article
number given on the type plate of the tool.
Recycle raw materials & batteries instead of
disposing of waste. The unit,
accessories, packaging & used
batteries should be sorted for
environmentally friendly recycling
in accordance with the latest
regulations.
Cause
Battery pack or batteries
empty
Battery too warm or
too cold
Measuring tool too warm
or too cold
Image memory fault
Image memory full
Measuring tool is fault
Measuring tool not recog-
nized by computer
Micro USB connection or
micro USB cable fault
-18-

ENVIRONMENT PROTECTION

Corrective Measure
Charge the battery pack or change the batteries.
Allow the battery to reach the correct temperature
or change it.
Allow the measuring tool to reach the correct
temperature.
Format the internal memory by deleting all images
(see "Delete all images", page 16). If the problem
persists, send the measuring tool to an authorized
Bosch after-sales service agent.
If required, transfer the images to another storage
medium (e.g. computer or notebook). Then delete
the images in the internal memory.
Send the measuring tool to an authorized Bosch
after-sales service agent.
Check whether the driver on your computer is up to
date. It may be necessary to have a newer operating
system version on your computer.
Check whether the measuring tool can be connected
to a different computer. If not, send the measuring
tool to an authorized Bosch after-sales service agent.