Siemens SINUMERIK 840D Operation/Programming Manual page 400

8
Alarms and Messages
8.1 Cycle alarms and messages
61121
61122
61124
61125
61126
61127
61128
61180
61181
61182
61183
61184
61185
61186
61188
61200
61201
61202
8-400
"Number of teeth/cutting edge
missing"
"Safety clearance in the plane
incorrectly defined"
"Infeed width is not programmed" In active simulation without a tool, a value for
"Technology selection in
parameter _TECHNO incorrectly
defined"
"Thread length too short"
"Speed ratio of tapping axis
incorrectly defined (machine data)"
"Insertion angle = 0 for insertion
via oscillation or helix"
"No name assigned to swivel data
block although machine data
$MN_MM_NUM_TOOL_CARRIER
> 1"
"NCK software version too old
(no TOOLCARRIER functionality)"
"Name of swivel data record
unknown"
"Retraction mode GUD7 _TC_FR
outside value range 0..2"
"No solution can be found with
current angle inputs"
"No or incorrect (min > max)
angle ranges declared for rotary
axes"
"Invalid rotary axis vectors"
"No axis name declared for 1st
rotary axis -> check CYCLE800
start-up"
"Too many elements in machining
block"
"Incorrect sequence in machining
block"
"Not a technology cycle"
Enter the number of teeth/cutting edges for the
active tool into the tool list.
The safety clearance is negative or zero. This is
illegal.
the infeed width must always be pro-
grammed.
Check settings in machine data 9855 and 9856.
Check thread geometry.
Check settings in machine data 31050 and
31060.
Use larger insertion angle.
Assign a unique name for the swivel data block.
Upgrade NCK software.
Check the name of the swivel data block.
Check installation and start-up of the swivel
cycle CYCLE800.
Check the angle entered for the swivelling of
the machining plane.
Check installation and start-up of the swivel
cycle CYCLE800.
Check installation and start-up of the swivel
cycle CYCLE800.
Check installation and start-up of the swivel
cycle CYCLE800.
Revise machining block, if necessary deleting
elements
Sort the machining block sequence.
Program technology block.
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
8
10.04
 Siemens AG, 2004. All rights reserved