Editing A G Code Program - Siemens SINUMERIK 840D Operation/Programming Manual

5
10.04
Scrolling through the
program
Stopping a search
Abort

5.12.2 Editing a G code program

Changing and saving G
blocks
Edit
Overwrite
Insert
Save
File
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
5.12 Editing part program blocks
Place the cursor in the program section.
Press one of the cursor keys.
You move up, down, left, or right in the part program.
You can interrupt a search at any time.
Press the "Abort" softkey.
You can edit the selected block and then save it.
Press the "Edit" softkey.
Edit the selected block in the program section.
You are automatically in overwrite mode.
- OR -
Press the "Overwrite" softkey.
The softkey changes to "Insert"
You can now insert blocks.
Press the "Save File" softkey.
The changes are applied in the file.
The workpiece graphics are redrawn.
5
Simulation
5-345