Door Lock - Siemens HiPath 1100 Series Programming Manual

Step by Step
1
1
Deleting an Entrance Telephone Assignment
Required: Programming Mode must be active (*95
31994).
1 5 Enter the code for programming.
...
4 Enter the slot to be deleted.
*
Delete the assignment of the Entrance Telephone to
the extension.
Enter the next slot.
or
Press this key.
#
Initial state for Programming Mode.
1. By default no slot is set as an Entrance Tele-
2. Each TFE Interface Module can be connect-
3. Each TFE Interface Module serves as an

Door Lock

This feature detects when there is a locking device
installed.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 6
... Enter the slot for the TFE Interface where the lock is
4
located (1 to 4).
or Activate/Deactivate the Door Lock:
* #
= To activate
*
= To deactivate (default)
#
Repeat these steps for any additional slot.
phone.
ed to one Entrance Telephone only.
interface for an Entrance Telephone or or
Pager. To provide these two interfaces two
modules must be used.
Entrance Telephone
99