Remove Housing Of The Ebike Iii Basic - GE eBike III basic Series Service Manual

r B
eMove HousIng of tHe e
r
eMove top Cover
1. Remove the saddle.
(When mounting the saddle after repair use a torque
wrench to tighten the screw with a torque of
25 Nm.)
2. Remove the lever for saddle height by turning it
counterclockwise.
3. Remove the two plastic caps (cap type 4) on both
sides.
4. Using a small screwdriver, cut into the plastic caps
covering the screws and remove the caps
(the caps will later be replaced by spare ones;
P/N 2018111-335).
5. Remove the two allen screws underneath the plastic
caps.
6. Remove the allen screw at the rear side of the top
cover.
- 42 -
III
Ike BasIC
eBike III basic / comfort 2018111-336 Rev. B