4Wd Gear Shift Lever; Reassembly - Suzuki Samurai 1986 Service Manual

4WD Gear Shift Lever

Check lower end of gear shift lever where gear
shift fork shaft contacts @ for wear and any
kind of damage. Worn or damaged shift lever
must be replaced with new one.
Fig. 14-42
14-14

14-8. REASSEMBLY

NOTE:
All parts to be used in reassembly must be
l
perfectly clean.
l Oil or grease sliding and rubbing surfaces of
transfer components just before using them
in reassembly with gear oil and SUZUKI
SUPER GREASE A (99000-25010).
Oil seals, "0" rings, gaskets and similar sealing
l
members must be in perfect condition. For
these members, use replacement parts in
stock.
Tightening torque is specified for important
l
fasteners - mainly bolts - of transfer and
other components. Use torque wrenches and
constantly refer to specified data given in
P. 14-23.
Input Shaft
Press-fit bearings onto both sides of input shaft
by using bearing installer (special tool).
Bearing installer (A) : (09913-84510)
Fig. 14-43