Installing
the SAECG
To install the M1754A SAECG application software perform the
Software
following steps.
Note
.I
u
Version A.02.XX or A.03.00 software must already be installed in the
cardiograph prior to installing SAECG software.
1. Press the (On-Standby) switch to place the cardiograph in Standby.
2. Insert the M1754A SAECG application disk in the cardiograph.
3. Press Con-Standby) to turn the cardiograph On. The message Load
SAECG application?
appears.
4. Press Yes. The copyright display appears briefly, then the
following display appears:
******
SAECG (M1754A - A.O1.OO)
The asterisks gradually extend across the display as the software
is installed. When installation is complete, the following display
appears:
Auto
3x4
Report
Format
01-26-92
01:23PM
M1754A Signal Averaged
ECG (SAECG) System
B-3