Toshiba LICSTAR-IV SE Instruction Manual page 46

EFFECT PANEL
3) Adjusting Speed
3.1) Speed adjustment from the EFFECT PANEL
Operating procedure
(1) Press the PATT button.
The PATT button lights up.
(2) Press the GO/STOP button for playback.
The STEP number now being played is displayed on the STEP number indicator.
(3) Press the EDIT button to enter edit mode. The EDIT button flashes.
[Press the EDIT button again to end edit mode.]
(4) Turn the SPEED wheel.
Adjust the speed of the pattern now being played on the EFFECT PANEL.
(5) Press the REC button. The EDIT button goes out.
The current speed is recorded.
[Operating the SPEED wheel]
Turn the wheel towards FAST
Turn the wheel towards SLOW
Notes
• The speed is not recorded if the LIGHTING CONTROL CONSOLE is turned off without the REC
button being pressed.
If the STOP button is pressed once and then the GO button is pressed again for the pattern without
the REC button being pressed, the last recorded speed is resumed.
• Even if the SPEED wheel is turned while the effect is stopped, the speed does not change.
To adjust the speed with lighting dimmed on the EFFECT PANEL, press GO with the effect master
fader set to 0.
• The moment the speed adjustment is recorded, effect playback is restarted.
: the speed is increased.
: the speed is decreased.
5-3