Message Lists - Sony VPL-AW10 Operating Instructions (VPLAW10 and VPLAW15) Operating Instructions Manual

Message Lists

Warning messages
Message
High temp.! Lamp off in 1
min.
Frequency is out of range!
Please check Input-A
Signal Sel.
Please replace the Lamp/
Filter.
Please replace the filter.
Please replace the filter.
Have you finished? Yes No
Projector temperature is
high. Cooling Setting
should be "High" if
projector is being used at
high altitude.
Caution messages
Message
x
Not applicable!
54
Cause and Remedy
c Turn off the power.
c Check to ensure that nothing is blocking the ventilation holes.
(1 page 13)
c Frequency is out of range. Input a signal that is within the
acceptable frequency range of the projector.
c Set "Input-A Signal Sel." in the Setup
"Computer" when an RGB signal is input from a computer.
(1 page 47)
c It is time to replace the lamp. Replace the lamp. (1 page 55)
c Also, replace the air filter too. Restart cleaning the Ventilation
holes (intake). (1 page 55)
If this message appears again after you replace the lamp and
filter, the lamp replacement process is not complete. Check the
lamp replacement process. (1 page 55)
Note
To clear this message, press any button either on the remote control
or the control panel of the projector once.
c It is time to replace the air filter. Replace the air filter. (1 page
58)
c It is time to replace the air filter. Replace the air filter. (1 page
58)
c If you replaced the air filter, select "Yes." If you did not replace
the air filter, select "No."
c Check to ensure that the Ventilation holes on the unit are not
covered. (1 page 13)
c When using the projector at high altitude, set the Cooling
Setting to "High". (1 page 46)
Note
When temperature inside the projector remains high, the Cooling
Setting is switched to "High" in 1 minute, then the fan speed
increases.
Cause and Remedy
c No signal is input in the selected input. Check connections.
(1 page 17)
c Press the appropriate button.
c The operation to be activated by the button is currently
prohibited.
menu to