Table of Contents
Advertisement
Tracking a Subject Automatically — Automatic Target Tracking Function
Hint
If you press any of the buttons from 1 through 6 on the Remote
Commander during a communication session, you can call up the value set
for that number.
On backup
The memories of the preset are erased when the I/1 switch on the
Multimedia Terminal Processor is set to off. To retain those memories, set
the BACKUP switch at the rear of the Camera Unit to ON.
Notes
• In the Camera Unit, the built-in lithium battery acts as the power source
for retaining the memories and is kept charged as long as the system is
used. However, if the system is used for shorter period of time with the
BACKUP switch set to ON, the battery is gradually discharged. If you do
not use the system at all for almost 12 weeks, the battery is completely
discharged. To retain the memories of the settings, you should recharge
the battery.
• To recharge the battery, connect the Camera Unit to the Multimedia
Terminal Processor and leave it for approximate 48 hours with the I/1
switch set to on.
You can have the camera memorize a particular color or brightness so that
it automatically tracks a subject having the memorized color or brightness.
If a subject almost goes off the screen, the camera performs the pan/tilt
action so that the subject is placed back in the middle of the screen.
Note
The automatic target tracking function is only available for the local
camera.
1
Open the Camera menu.
2
Select Auto Track with the joystick on the Remote Commander, then
press the joystick.
The frame appear on the monitor screen.
Camera
Preset Save
Preset Load
Adjustments
Auto Track
Chapter 2 Basic Operation During a Meeting
(Continued)
75
Advertisement
Table of Contents
