On Screen Messages - Sony PCS-6000 Operating Instructions Manual

On Screen Messages

The following messages appear on the TV monitor
when using the Multimedia Terminal and give
instructions on dealing with them.
Message
INCORRECT DIALING SETUP
CANNOT COMPLETE CONNECTION (The following code
and message appear.)
0 Unknown network error:
1 Number does not exist:
2,3,6 Network congestion:
16 Normal disconnection:
17 Line is busy:
18,19 System not responding:
21 Call rejected:
22 Called party number changed:
26 Connection restoration request:
27 Remote system out of order:
28 Invalid number entered:
31, 34, 41 – 44, 47
Network not available:
50 Not a Subscriber:
57,58 Bearer capability not authorized:
70 Restricted capability:
88 Terminal attribute error:
91, 95 – 102, 111
Protocol error:
128 H.221 negotiation timeout:
130 No message
131 Board mismatch:
132 Invalid SPID:
133 SPID timeout:
134 Physical link synchronization error:
135 No message
136 No message
137 No message
144, 145
Bonding negotiation timeout:
177 LAN connection timeout:
178 LAN connection rejected:
179 DNS error:
180 Dialing your own number is invalid:
181 GateKeeper error:
FAR END INACTIVE
CLOSE THIS MENU TO CONNECT LINE
CANNOT ESTABLISH ALL CONNECTIONS
124
Appendix
Remedy
Make sure the selected entry is correctly registered.
—
Try again later.
Check the number and try again.
Try again later.
(The line has been disconnected normally.)
Try again later.
Check if the remote system is connected.
Check if the remote system is connected.
Check the number and try again.
Try again later.
Check if the remote system is operational.
Check the number and try again.
Try again later.
Check the remote party's facility contract.
Check if the line rate is set correctly.
Set the line rate to 56K and try again.
Check the connection of the remote system.
Turn off and restart the system and try again.
Turn off and restart the system and try again.
The V.35 cable is not connected.
Check the optional line interface boards.
Reregister the SPID.
Check the connection of the ISDN cable.
The FPGA download of the V.35 interface board was failed.
Turn off and restart the system and try again.
The FPGA download of the RS-449 interface board was
failed. Turn off and restart the system and try again.
Set Line I/F to PRI
Turn off and restart the system and try again.
Try again later.
Try again later.
Please check DNS.
Please check the address and try again.
Please check the address and try again.
The remote party operates the menu.
Close the menu.
Check to see if your partner's telephone number is the correct
one.