Suzuki SQ416 Service Manual page 95

7B1-24 AUTOMATIC TRANSMISSION (4 A / T)
43) For J20 and H25 engines, perform the following procedures.
[J20 and H25 engines]
a) Clean mating surface of transmission case (1) and adapter
case (2) and apply sealant "A" to adapter case (2).
"A" sealant: 99000-31110
b) Tighten adapter case bolts to specified torque.
Tightening torque
Adapter case bolt (a): 42 N
1. Adapter case
44) Apply A/T fluid to new O-ring and install it to vehicle speed sen-
sor (1) and then install vehicle speed sensor (1) to adapter
case (2).
45) After turning manual shift shaft fully rearward, turn it back by 2
notches and set it to "N" range. Then install shift switch, lock
washer and set nut and tighten set nut. After tightening it, bend
claws of lock washer.
Tightening torque
Manual shift shaft set nut (a):
4 N
46) With neutral reference line (1) and cut groove (2) in switch
aligned, tighten lock bolt.
Tightening torque
Shift switch lock bolt (b):
5.5 N
.
m (0.4 kg-m, 3.0 lb-ft)
.
m (0.55 kg-m, 4.0 lb-ft)
.
m (4.2 kg-m, 30 lb-ft)