Connected Via Ethernet (Only 840D Sl) - Siemens SINUMERIK Series Function Manual

H1: Manual and handwheel travel
3.10 Start-up: Handwheels
3.10.5

Connected via Ethernet (only 840D sl)

Parameter setting
The parameters for handwheels connected via Ethernet modules, e.g. machine control panel
"MCP 483C IE", "HT 8", or "HT 2", are assigned in the following NC machine data:
● MD11350 $MN_HANDWHEEL_SEGMENT[< x - 1 >] = 7
● MD11351 $MN_HANDWHEEL_MODULE[< x - 1 >] = 1
● MD11352 $MN_HANDWHEEL_INPUT[< x - 1 >] = y
where x = 1, 2, 3, etc. (handwheel number in the NC)
Handwheel interfaces at the Ethernet Bus
The handwheel interfaces at the Ethernet bus are numbered on the basis of the following
considerations:
● The sequence of the operator component interfaces is: MCP1, MCP2, BHG
● Each operator component interface has two handwheel interfaces
● Operator components: MCP 483C IE
● Operator components: HT 8
● Operator components: HT 2
206
When connected via Ethernet modules, the segment always has to be entered as 7
(Ethernet).
When connected via Ethernet modules, the module always has to be entered as 1.
where y = 1, 2, 3, etc. (handwheel interface at the Ethernet bus)
A maximum of two handwheels can be connected to an MCP 483C IE via connections
X60 and X61 . The assignment of the connections in the operator component interface is:
– Connection X60: 1st handwheel in operator component interface MCP1 /MCP2
– Connection X61: 2nd handwheel in operator component interface MCP1 /MCP2
The handwheel of the HT 8 is always assigned to the 1st handwheel of operator
component interface MCP1 /MCP2 .
The handwheel of the HT 2 is always assigned to the 1st handwheel of operator
component interface BHG .
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Extended Functions