Brother MFC Series Service Manual page 183

• Attach the tube clamp by aligning it to the dented part of the Tube support plate shown in
the illustration in the previous page.
• After installing the Ink refill ASSY, route the Ink supply tubes to the tube guide based on
the color order described in the previous page without overlapping. Next, set it into the
sponge and route it to the Tube support wire elbow.
• Attach the Head joint to the Head/carriage unit using the joint spring as shown below.
Make sure that all of the four Ink supply tubes are routed in front of the guide boss.
Head joint spring
Head joint
Ink supply tubes
Head joint
rubber
Upper cover
Guide boss
Carriage flat cable
3-75
Head joint spring
Head/carriage unit
Head joint
Head/carriage unit
(3_053L)
Confidential