Yamaha DME4io-ES Service Manual page 54

DME4io-ES/DME8i-ES/DME8o-ES
2. Operation
2-1. Starting Test Program
Set the DIP-SWITCH on the rear panel as shown below, which shows rear view, and turn on the power.
Left
U U D U U D
2-2. Starting TeraTerm
• Start the DME Satellite in the test program mode. When the Ethernet is in a communicable condition, the
NETWORK LED will light.
• Using an explorer in PC, click "diag_start" and TeraTerm will start.
"Diag_start" is in "C:¥TOOLS_SATELLITE¥tools¥TeraTerm-Setting".
• When "Press [ENTER]" is displayed in the TeraTerm screen, press the [ENTER] key of the PC. Testing Category
Selection List Screen appears on the display. If "Connection timed out" is displayed, it indicates an unsuccessful
connection. Restart TeraTerm. If the connection is unsuccessful still, check the LAN connection, turn off and on the
DME Satellite, and then start TeraTerm.
∗ If the TeraTerm does not start when the "diag_start" is clicked, update the program and boot area. Refer to P. 102
for update of the program and boot area.
** Diag Category Menu **
* 01 Product
02 CPU Sheet
03 DSP Sheet
04 ES Sheet
05 AD Sheet
06 DA Sheet
07 SUB Sheet
08 ==> Exit Diag Mode
[ENTER]:AUTO, [0]:MANUAL
Ethernet Mac Address
EtherSound Mac Address 00.0E.55.XX.XX.XX
Boot Version
Program Version
EtherSound Version 0C0A
[Testing category selection list screen sample]
• Use [↑] or [↓] key of PC to select "01 Product" and press the [0] (zero) key (MANUAL) to enter manual test.
Testing Item Selection List appears on the display
• Use [↑] or [↓] key of PC to select a test item and press the [ENTER] key.
OK or NG will be displayed as test result in the Testing Item Selection List.
54
Right
U: Up
D: Down
00.A0.DE.XX.XX.XX
V3.00
V3.01