Electronic Operator Interface; Eoi Features - Toshiba H7 Operation Manuals

Electronic Operator Interface

The H7 Electronic Operator Interface (EOI) is comprised of an LCD display, two LEDs, a rotary
encoder, and eight keys. These items are described below and their locations are provided in
Figure 18 on pg.
The EOI can be mounted remotely from the ASD as described in
dimensional requirements may also be found in
specified dimensions may cause deformation of the outer surface of the bezel as shown in
pg. 202 and should be avoided.
The interface can operate up to distances of 15 feet from the ASD via the Common Serial (TTL) Port. For
distances beyond 15 feet, the RS-485 port is recommended.

EOI Features

LCD Display — Displays configuration information, performance data (e.g., motor frequency, bus
voltage, torque, etc.), and diagnostic information.
Local|Remote Key — Toggles the system to and from the Local and Remote modes. The LED is on
when the system is in the Local Command mode. The Local mode allows the Command and Frequency
control functions to be carried out via the EOI.
The Remote mode enables the Command and Frequency control functions to be carried out via the
Control Terminal Strip, LED Keypad, RS232/485, Communication Card, or Pulse Input. The
selection may be made via Program
Mode.
Note: The LED Keypad is under development and is unavailable at the time of the release of
this manual.
The availability of the Local mode of operation (Command and Frequency control) may be disabled via
Program ⇒ EOI Option Setups
may be reinstated by changing this setting or performing a Reset (see F007).
Enter Key — Selects a menu item to be changed or accepts and records the changed data of the selected
field (same as pressing the Rotary Encoder).
Esc Key — Returns to the previous level of the menu tree, toggles between the Panel and the Frequency
Command screens, or cancels changes made to a field if pressed while still in the reverse video mode
(dark background/light text).
Run Key — Issues the Run command while in the Local mode.
Run Key Status LED — Illuminates green while stopped or red while running.
Stop Key — Issues the Off command (decelerates to Stop at the programmed rate) if pressed once while
in the Local mode or initiates an Emergency Off (terminates the ASD output and applies the brake if so
configured) if pressed twice quickly from the Local or Remote modes.
Up Key — Increases the value of the selected parameter or scrolls up the menu listing (continues during
press and hold).
Down Key — Decreases the value of the selected parameter or scrolls down the menu listing (continues
during press and hold).
H7 ASD Operation Manual
24.
⇒ Fundamental Parameters
⇒ Local/Remote
Appendix C on pg.
Appendix C. Using a screw length that exceeds the
⇒ Standard Mode Settings
Key. The availability of the Local mode of operation
200. The mounting
Figure 33 on
⇒ Command
23