Table of Contents
Advertisement
WIT-300H User Manual
Issue: 0.4C
5.0.2
MFIM setup
MFIM IP address
WIT-300H should know the IP address of MFIM to initially request registration. For setup of MFIM IP address
please refer to subsection 6.5.5.
Network mask
Since MFIM of IPECS resides in wired network, network mask should be specified as well. For setup of MFIM
network mask, please refer to subsection 6.5.5.
5.0.3
Rebooting WIT-300H
After the proper setup of both wireless LAN and MFIM IP address, just turn off the phone and turn it on. The WIT-
300H will start registration and show its station number which is given by MFIM.
5.1
Basic Feature
User can use various telephone features with a WIT-300H registered to MFIM module in a
5.1.1
Turing the Power On and Off
Turning the Phone On
When pressing [END] (
The following describes the sequence of power-on:
1. Install a charged battery pack
2. Press for a few seconds until the blue light in the right upper of the phone is on and off.
3. WIT-300H shows power-on animation
3. WIT-300H tries to do locking the access point while blinking Antenna Icon and RSSI level.
4. If Antenna Icon and RSSI level stop blinking, it means all procedures for initial setup are completed.
5. WIT-300H searches MFIM and sends a registration message to MFIM.
6. if the WIT-300H receives REGISTER RESPONSE, store station number and display station number :
Refer to Idle state LCD display.
Turning the Phone Off
To turn off the WIT-300H, press [END] (
This Document Contains proprietary information and may not be reproduced or copied without express
Written permission of a duly authorized representative of LG Electronics company
) button, the power is turned on and the WIT-300H goes to an idle state.
) until the display turns off.
17
Date: 24/May/2005
iPECS
system.
Advertisement
Table of Contents
