Additional Modules; Control Supply Module; Sensor Module Cabinet Smc10 / Smc20 - Siemens Sinamics s120 Commissioning Manual

4.1.3

Additional modules

4.1.3.1

Control Supply Module

Table 4- 33 Control Supply Module – description of the LEDs
LED Color State
READY – off
Green Continuous
light
DC LINK – off
Orange Continuous
light
Red Continuous
light
4.1.3.2

Sensor Module Cabinet SMC10 / SMC20

Table 4- 34 Sensor Module Cabinet 10/20 (SMC10/SMC20) – description of the LEDs
LED Color
RDY –
READY
Green
Orange
Red
Green/red Flashing
Green/
orange
or
Red/
orange
STARTER Commissioning Manual
Commissioning Manual, (IH1), 07/2016, 6SL3097-4AF00-0BP5
Description, cause
Electronic power supply is missing or outside permissible
tolerance range.
Component is ready to operate.
Electronic power supply is missing or outside permissible
tolerance range.
DC link voltage within permissible tolerance range.
DC link voltage outside permissible tolerance range.
State Description, cause
off Electronic power supply is missing or outside permissible
tolerance range.
Continu- The component is ready for operation and cyclic DRIVE-
ous light CLiQ communication is taking place.
Continu- DRIVE-CLiQ communication is being established.
ous light
Continu- At least one fault is present in this component.
ous light
Note:
LED is controlled irrespective of the corresponding messag-
es being reconfigured.
Firmware is being downloaded.
light 0.5
Hz
Flashing Firmware download is complete. Wait for POWER ON
light 2 Hz
Flashing Component recognition via LED is activated (p0144).
light
Note:
Both options depend on the LED status when module
recognition is activated via p0144 = 1.
Diagnostics
4.1 Diagnostics via LEDs
Remedy
–
–
–
–
–
Remedy
–
–
–
Remedy and
acknowledge fault
–
Carry out a POWER
ON
–
327