Upgrading The Plc Basic Program - Siemens SINUMERIK 840D sl Configuration Manual

3.6

Upgrading the PLC basic program

If you upgraded the firmware of an NCU or carried out a project migration, you should then
also upgrade the PLC basic program to the current version.
However, it is essential that you check beforehand whether you would inadvertently
overwrite your own blocks (see requirement).
Requirement
● Block number ranges of the SINUMERIK PLC basic program in the project are not
occupied by blocks of other creators or you have checked which blocks of other creators
are located in the SINUMERIK number range (Page 56).
Procedure
To upgrade the PLC basic program, proceed as follows:
1. Switch to the "Libraries" task card and open the PLC basic program that matches the
firmware version of the inserted NCU:
– SINUMERIK 840D sl PLC basic program V4.5.x.x
– SINUMERIK 840D sl PLC basic program V4.7.x.x
– SINUMERIK 840D sl PLC basic program V4.8.x.x
See also: Replacing a device or upgrading firmware (Page 25), Using copy templates
(Page 48)
2. Open the folder "Master copies > 840D sl PLC Basic Program (upgrade)"
SINUMERIK STEP 7 Toolbox V14 SP1
Configuration Manual, 05/2017
Programming the PLC
3.6 Upgrading the PLC basic program
65