Adding The Plc Basic Program - Siemens SINUMERIK 840D sl Configuration Manual

Programming the PLC

3.3 Adding the PLC basic program

3.3 Adding the PLC basic program
You can copy blocks of the PLC basic program from the respective system library. The
"840D sl PLC Basic Program" folder that it contains is meant for creating a completely new
project. You can copy the PLC basic program blocks in their entirety or individually.
Requirement
● A SINUMERIK 840D sl NCU is inserted.
● In the project, there are no blocks from other creators in the range of numbers of the PLC
basic program (Page 56).
Procedure
To copy program blocks of the basic program from a master copy to the program blocks
folder of the project tree, proceed as follows:
1. Switch to the "Libraries" task card and open the PLC basic program that matches the
firmware version of the inserted NCU:
– SINUMERIK 840D sl PLC basic program V4.5.x.x
– SINUMERIK 840D sl PLC basic program V4.7.x.x
– SINUMERIK 840D sl PLC basic program V4.8.x.x
See also: Replacing a device or upgrading firmware (Page 25)Using copy templates
(Page 48)
2. Open the folder "Master copies > 840D sl PLC Basic Program"
3. You have several options for copying the PLC basic program blocks to your project:
– Copying the PLC basic program including folder structure as a whole
60
Drag and drop the master copies folder "840D sl PLC BP" into the folder Program
blocks, e.g. under "CNC_1 > PLC_1 > Program blocks".
SINUMERIK STEP 7 Toolbox V14 SP1
Configuration Manual, 05/2017