Siemens SINUMERIK 828D Operating Manual page 463
Hmi sl milling
Hide thumbs
Also See for SINUMERIK 828D:
- Function manual (1799 pages) ,
- Commissioning manual (1167 pages) ,
- Operating manual (926 pages)
Table of Contents
Advertisement
Requirement
Window 1 / window 2, the symbol tables or the list of cross references is opened.
Procedure
Further search options
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
1.
Press the "Find" softkey.
A new vertical softkey bar appears. The "Find / Go To" window opens
at the same time.
2.
Select the "Find operand" entry in the first input field if you are
searching for a specific operand and enter the search term in the
"Find" input field.
3.
Select the search range (e.g. Find all).
4.
Select the "In this program unit" or "In all program units" entry if you
are in "Window 1" or "Window 2" or in the symbol table in order to
restrict the search.
5.
Press the "OK" softkey to start the search.
If the operand you are searching for is found, the corresponding line is
highlighted.
Press the "Continue search" softkey if the operand found during the
search does not correspond to the element you are looking for.
- OR -
Press the "Cancel" softkey if you want to cancel the search.
1.
Press the "Go to start" softkey to jump to the start of the ladder
diagram in window 1 or window 2, or the list (cross references, symbol
table).
2.
Press the "Go to end" softkey to jump to the end of the ladder diagram
in window 1 or window 2, or the list (cross references, symbol table).
Ladder add-on tool
19.16 Searching for operands
463
Advertisement
Table of Contents
