Call Parking Recall Time; Tie Inter-Digit Time; Disa Prolong Time - Panasonic KX-TD500 Programming Manual

System
Parameter
Default
Value Range
Description/Function
Reference
Parameter
Default
Value Range
Description/Function
Reference
Parameter
Default
Value Range
Description/Function
Reference
86

Call Parking Recall Time

60 s
0-1800 s
Specifies the length of time in seconds the system is to wait before
alerting (Call Parking Recall) the extension who parked the call.
Note
• If "0" is specified, Call Parking Recall does not occur.
• 1.10 Holding Features (F/G)
– Call Park
• 2.4.1 Holding a Call (U/M)

TIE Inter-digit Time

5 s
3-30 s
Specifies the maximum time allowed between digits on a TIE call
after it was received by the system.
• 3.1 TIE Line Features (F/G)
– TIE Line Service

DISA Prolong Time

3 min
0-7 min
A CO-to-CO line call duration is initially limited by "CO-to-CO
Line Call Duration Time." However, prolonging the CO-to-CO line
call duration is possible. To prolong the call duration, the caller
should press any dialpad key except . The amount of prolonging
is set by "DISA Prolong Time" ( 0-7 minutes). (If this is set to zero,
then prolonging is disabled.) Depending on "13. DISA prolong
operation" setting in Section "2.8 System Option," the call
duration can be prolonged 10 times or without limit.
• 1.5 Attended Features (F/G)
– Direct Inward System Access (DISA)
Programming Guide