Table of Contents
Advertisement
CAUTION:
IMPORTANT:
before the glue hardens again.
NOTE:
You will need a stand to hold the display or have way to secure the display panel assembly at a 90
degree angle after you release the left side of the display. The display panel assembly will need to be secured
as you release the battery and display flex cables.
1.
Preheat the hot plate to 80.0° C (176.0° F).
2.
Place the device with the display side down on the hot plate for 8 minutes, and then carefully remove
the device to your workstation.
NOTE:
3.
Insert a spudger (1) between the bottom of the display panel and chassis, move the spudger from left to
right, and then place a 2 inch suction cup (2) on the bottom right and gently pry the right edge of the
display away from the chassis.
4.
Place the suction cup (3) on the bottom left and gently pry the left edge of the display away from the
chassis.
5.
Place the suction cup (4) in the middle of the display and gently pry the rest of the display away from the
chassis.
20
Chapter 5 Removal and replacement procedures
You will need heat protective gloves or a way to safely move the device once it is heated.
Once the device is heated, you will need to work quickly to remove the display panel assembly
There is a display flex cable on the top of the right side.
Hide quick links:
Advertisement
Table of Contents
