Example: Configuring Tdm Shdsl For Carrying The Pra Service (Based On The Sip Protocol) - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Result
The phone set connected to the PBX can communicate with a phone set in the PSTN network
in the normal state.
Configuration File
interface edt 0/3
board workmode voice
runmode service
set clockmode line 0
shdslport signal 16 CCS
quit
huawei(config)#sigtran
huawei(config-sigtran)#iua-linkset add 1 mgid 0 jointly-work enable trafficmode
override
iid-map 2 pendingtime cs-mode client
huawei(config-sigtran)#iua-link add 15 1 1401 10.13.4.116 1400 10.14.1.2
jointly-work-with primary-mgc priority 3
esl user
mgprauser add 0/3/16 0 0 terminalid 0
quit
save
3.3.12 Example: Configuring TDM SHDSL for Carrying the PRA
Service (Based on the SIP Protocol)
The MA5600T/MA5603T/MA5608T is connected to the PBX in the TDM SHDSL mode and
then connected upstream to the IP network in the GE mode.
Service Requirements
l
l
The following figure shows an example network of TDM SHDSL for carrying the PRA service.
Figure 3-20 Example network of TDM SHDSL for carrying the PRA service
Data Plan
The following table lists the data plan for configuring TDM SHDSL for carrying the PRA
service.
Issue 01 (2014-04-30)
The PBX is connected to the IP network over a long distance to carry the PRA service.
The configuration data is transparently transmitted on the MA5600T/MA5603T/
MA5608T.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuring the DSLAM Services
349