Siemens HiPath 3000 Service Manual page 974

service.fm
Service
Guided Maintenance
Table 12-7 HiPath 3000 Class B Error Messages
No.
35 No ELIC interrupts
36 SDRAM: Access to protected area
37 SDRAM: Write error, wrong address
38 SDRAM: Read error, wrong address
Error Class B-30 - Firmware/Loadware
6 HDLC Controller Error on board
Error Class B-40 - MMC
0 MMC defective
Error Class B-41 - LAN
4 Send: Ethernet driver not ready
8 Send: More than 15 futile attempts
9 Send: Delayed collision detection
10 Send: Carrier loss
11 Receive: Frame error
12 Receive: FIFO error
13 Receive: Checksum error
14 Receive: Defective receiving buffer
15 Receive: Frame too short
16 Receive: Frame too long
17 Receive: Delayed collision detection
18 Receive: Partial deletion of data due to the
existing write protection
12-56
Meaning Action
Recovery
Hard restart Notify appropriate service
Hard restart
Hard restart
–
Reload board
Hard restart
–
sporadically, no action is
–
–
For errors that appear reg-
–
–
–
–
–
–
–
–
–
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
Action
Technician
support
Replace board
Replace MMC
For errors that appear
necessary.
ularly, replace the LIM
module. If this does not
correct the error, check
the LAN configuration.