Programming technology functions (cycles)
8.4 Milling
Parameter
Description
Machining type
Plane by plane
Solid machine circular pocket plane-by-plane
Helical
Solid machine circular pocket helically
Machining
Single position
position
A circular pocket is machined at the programmed position (X0, Y0, Z0).
Position pattern
Several circular pockets are machined in a position pattern
(e.g. full circle, pitch circle, grid, etc.).
The positions refer to the reference point:
X0
Reference point X – (only for single position)
Y0
Reference point Y – (only for single position)
Z0
Reference point Z
(only for G code)
Face C: The positions refer to the reference point:
X0 or L0
Reference point X or reference point length polar – (only for single position)
Y0 or C0
Reference point Y or reference point angle polar – (only for single position)
Z0
Reference point Z – (only for single position)
(only for
ShopTurn)
Face Y: The positions refer to the reference point:
CP
Positioning angle for machining area – (only single position)
X0 or L0
Reference point X or reference point length polar – (only for single position)
Y0 or C0
Reference point Y or reference point angle polar – (only for single position)
Z0
Reference point Z – (only for single position)
(only for
ShopTurn)
Peripheral surface C: The positions refer to the reference point:
Y0 or C0
Reference point Y or reference point angle polar – (only for single position)
Z0
Reference point Z – (only for single position)
X0
Cylinder diameter ∅ – (only for single position)
(only for
ShopTurn)
Peripheral surface Y: The positions refer to the reference point:
C0
Positioning angle for machining surface – (only for single position)
Y0
Reference point Y – (only for single position)
Z0
Reference point Z – (only for single position)
X0
Reference point X – (only for single position)
(only for
ShopTurn)
∅
Diameter of pocket
398
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
Unit
mm
mm
mm
mm
mm or
degrees
mm
Degrees
mm
mm or
degrees
mm
mm or
degrees
mm
mm
Degrees
mm
mm
mm
mm
Turning