Auto-Toner Sensor (S6); Drum Thermistor (Thms4); Guide Roller / Developer Sleeve - Toshiba e-STUDIO182 Service Manual

11.6.4

Auto-toner sensor (S6)

(1) Remove the developer material.
P.11-12 "11.6.2 Developer material"
(2) Place the developer unit upside down.
Disconnect 1 connector, release 1 latch, and
then rotate the auto toner sensor counter-
clockwise to take it off.
11.6.5

Drum thermistor (THMS4)

(1) Remove the developer material.
P.11-12 "11.6.2 Developer material"
(2) Disconnect 1 connector, remove 1 screw and
take off the drum thermistor.
11.6.6

Guide roller / Developer sleeve

(1) Remove the developer material.
P.11-12 "11.6.2 Developer material"
(2) Remove 2 screws and take off the recovered
toner supply unit.
e-STUDIO182/212/242
DEVELOPMENT SYSTEM
Connector
Drum thermistor
Connector
© 2009 TOSHIBA TEC CORPORATION All rights reserved
11 - 14
Auto toner sensor
Fig. 11-14
Fig. 11-15
Recovered toner
supply unit
Fig. 11-16