Installation guide for Cisco TelePresence MX700 Single camera - Floor stand
7
Fasten left monitor to floor stand and connect power cable
4 × M6x90
(countersunk)
4 × M6x35
(countersunk)
1
78-100218-01 A0 | 2014 APRIL | © 2014 Cisco Systems, Inc. All rights reserved.
Enter four screws from
front and four screws from
underneath. Then, tighten
all screws.
A power cable is strapped
2
at the rear of the monitor.
Connect it to the close-by
socket.
Let the other end hang
freely. It will be connected to
the right monitor in step 9.
Page 11