Radio Reassembly - Detailed; Speaker Reassembly; Front Circuit Board, Display Module And Keypad Reassembly; Figure 6-13. Speaker Reassembly - Motorola CP185 Basic Service Manual

Maintenance – CP185: Disassembling and Reassembling the Radio – General
6.4.2 Radio Reassembly – Detailed

6.4.2.1 Speaker Reassembly

1. Place the Speaker Felt (6) onto the grille area.
2. Align the speaker wire at three o'clock position and push down the speaker until fully adhere onto
the front housing.
3. Align the Speaker Insulator (9) at twelve o'clock position and push down until fully adhere onto the
speaker.
4. Install the Speaker Retainer (8).
5. Tighten the Speaker Retainer to the housing with a Phillips screwdriver torque to
0.86 Ib-in – 1.04 lb-in. (Refer Table 6-1 on page 6-14 for torque in other units).
Speaker Retainer
Speaker Insulator
Speaker
Speaker Felt

6.4.2.2 Front Circuit Board, Display Module and Keypad Reassembly

1. Place and align the LCD (34) onto the front housing.
2. Place and align the Keypad (39) onto the keypad slot. Apply force around the keypad and ensure
the keypad sealing rib is perfectly seated onto the keypad slot. (Refer Figure 6-14).

Figure 6-13. Speaker Reassembly

Figure 6-14. LCD and Keypad Reassembly

LCD
Keypad
Poron Pad
6-11