Multi Control; Configuring Settings For Multi Control - Samsung PE40C User Manual

8
System
8.2

Multi Control

m
MENU [
Assign an individual ID to your product.

8.2.1 Configuring settings for Multi Control

ID Setup

Assign an ID to a set. (Range: 0~99)
Press or
ID Input

Enter the ID number of the product connected to the input cable for input signal reception.
Enter the number you want using the number buttons on the remote control.
MDC Connection

Select a method to connect to MDC to receive the MDC signal.
RS232C MDC

Communicate with MDC via the RS232C-stereo cable.
RJ45 MDC

Communicate with MDC via the RJ45 cable.
DisplayPort Daisy Chain

To display the [DP IN] video input through the [DP OUT] output port, select a device connection
method from Single Stream Transport (SST) and Multi Stream Transport (MST).
Clone: In this Single Stream Transport (SST) output mode, the same screen output is displayed

on two display devices connected.
Expand: In this Multi Stream Transport (MST) mode, a different screen output is displayed on

two display devices connected.
Refer to 76 page for details about the
] System Multi Control
to select a number, and press [
- If Clone is selected, the
- Clone mode is enabled if the input source is a digital input other than DisplayPort, such
as DVI, HDMI, MagicInfo, or PIM.
- If Expand is selected, the
- The mode functions only on a PC that supports DisplayPort 1.2 MST.
- For Full HD resolution (1920x1080) displays, a maximum of four displays can be
connected.
[ ]
ENTER
].
PC recognizes the two displays as a single monitor.
PC recognizes the two displays as separate monitors.
MDC menu.
152
8 System