Makita T221D Instruction Manual page 10

Driving staples
Place the tool on the material to be fastened
so
that the front and the rear of the tool
contact the material flat. Do not tip the
tool t o the right or left side.
Hold
the tool
firmly against the material, Then pull the
trigger to drive the staples.
If the staples are driven too shallow, press
the tool head as shown in the figure and
drive the staples.
If the staples are s t i l l driven too shallow,
adjust the driving depth by turning the nut
clockwise. Refer to "Depth adjustment".
CAUTION
:
Do
not operate the tool without staples. I t
shortens the service life of the tool.
If the tool becomes jammed, do
as
follows. First, remove the battery cartridge. Open the
sub-magazine and remove the stuck staple using
a
screwdriver or the like.
Sight window
There
is a
convenient sight window on the
tool side. Use this sight window to check
if there are staples in the magazine. When
staples are not visible through the window,
load staples into the magazine.
Staples
0
Handle the staples and their box carefully. If the staples have been handled roughly,
.Avoid storing the staples in a very humid or hot place or place exposed to direct sun-
0
Do not attempt to use staples that appear to be damaged, bent, rusty or corroded.
they may be bent out of shape, causing poor staple feed or jamming.
light.
10