Table of Contents
Advertisement
1. Lock-off button
2. Switch trigger
ASSEMBLY
1
1. Clamping screw
1
1. Hex wrench
2. Shaft lock
10
Switch action
001400
1
2
CAUTION:
•
Before plugging in the tool, always check to see that the
switch trigger actuates properly and returns to the "OFF"
position when released.
To prevent the switch trigger from being accidentally pulled, a
lock-off button is provided. To start the tool, push in the lock-
off button and pull the switch trigger. Release the switch trig-
ger to stop.
Electric brake
This tool is equipped with an electric blade brake. If the tool
consistently fails to quickly stop blade after switch trigger
release, have tool serviced at a Makita service center.
The blade brake system is not a substitute for lower guard.
NEVER USE TOOL WITHOUT A FUNCTIONING LOWER
GUARD. SERIOUS PERSONAL INJURY CAN RESULT.
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Removing or installing saw blade
001412
CAUTION:
•
Be sure the blade is installed with teeth pointing up at
the front of the tool.
•
Use only the Makita wrench to install or remove the
blade.
To remove the blade, first remove the clamping screw which
secures the dust box, then remove the dust box.
001421
Press the shaft lock so that the blade cannot revolve and use
the wrench to loosen the hex bolt counterclockwise. Then
remove the hex bolt, outer flange and blade.
2
Advertisement
Table of Contents
