Makita 2704 Instruction Manual page 13

Table insert (Part No. 317934-3)
Spindle
CUT
WIDTH
1/8"
1/4"
5/16"
3/8"
7/16"
1/2"
9/16"
5/8"
11/16"
3/4"
13/16"
CAUTION:
• For a 1/8" cut width, the outside cutter is assembled
to the spindle in the same manner as the saw
blade.
• The outer flange must be used for each cut width.
• The hex nut alone must not be used to secure the
dado on to the spindle.
006176
Outside
Inner
Inner
Cutter
flange
flange
When cutting grooves, use this table insert instead of the
standard table insert.
To install the dado head set, proceed as follows:
1. Turn the tool off and unplug it before installing.
2. Remove the blade guard with the spreader.
3. Install the dado head set with the teeth pointing
down at the front of the table.
4. Use the chart below to select the proper cutters to
obtain the various cutting widths.
1/8"
1/16"
Outside
Inside
Inside
Cutter
cutter
cutter
x2
x2
x3
x3
x4
x4
NOTE:
• When widths slightly greater than the above are
required, fit the paper washers in between the
inside and outside cutters to adjust the width.
5. Arrange the cutters so that the tips of the inside cut-
ters are positioned at the gullets of the outside cut-
ter. When more than one inside cutter is used,
space the tips of the inside cutters equidistantly in
13
006177
Outer
Hex
flange
nut