Makita 2414DB Instruction Manual page 7

(B)
(A)
1. Stopper plate
4
1. Socket wrench
2. Guide plate
3. Move
4. Hex bolts
3
1. Socket wrench
2. Guide plate
3. Hex bolts
Stopper plate
003757
1
The stopper plate prevents the cut-off wheel from contacting
the workbench or floor. When a new wheel is installed, set
the stopper plate to position (A). When the wheel wears
down to the extent that the lower portion of the workpiece is
left uncut, set the stopper plate to position (B) to allow
increased cutting capacity with a worn down wheel.
Interval between vise and guide plate
003758
1
The original spacing or interval between the vise and the
2
guide plate is 0 - 170 mm (0 - 6-11/16"). If your work requires
wider spacing or interval, proceed as follows to change the
spacing or interval.
3
Remove the two hex bolts which secure the guide plate.
Move the guide plate as shown in the figure and secure it
using the hex bolts. The following interval settings are possi-
ble:
35 - 205 mm (1-3/8" - 8-1/16")
70 - 240 mm (2-3/4" - 9-7/16")
003759
CAUTION:
• Remember that narrow workpieces may not be secured
safely when using the two, wider interval settings.
Setting for desired cutting angle
003760
1
To change the cutting angle, loosen the two hex bolts which
2
secure the guide plate. Move the guide plate to the desired
angle (0° - 45°) and tighten the hex bolts securely.
CAUTION:
• Never perform miter cuts when the guide plate is set at
the 35 - 205 mm (1-3/8" - 8-1/16") or 70 - 240 mm
(2-3/4" - 9-7/16") position.
7