Advertisement
Available languages
Available languages
Installation
Instructions
Minimum
Clearance
Other Than Alcove or Closet Installation
Minimum clearance to combustible surfaces and for air opening are: 0 in. clearance both sides and rear. Consideration must
be given to provide adequate clearance for installation and service.
_-I PREPARING FOR INSTALLATION
OF NEW APPLIANCE
REMOVING LINT FROM WALL EXHAUST
OPENING
• Remove and discard existing plastic or metal foil
transition duct and replace with UL listed transition duct.
WALL
/
INTERNAL DUCT
CHECK T HAT EXHAUST
OPENING
HOOD DAMPER OPENS
ANDCLOSES FREE LV.
TILT THE APPLIANCE
SIDEWAYS AND REMOVE
THE FOAM SHIPPING PADS
BY PULLING AT THE SIDES
AND BREAKING THEM
AWAY FROM THE APPLIANCE
LEGS. BE SURE TO REMOVE
ALL OF THE FOAM PIECES
AROUND THE LEGS.
After the machine is in the
home, remove remaining
packing material/carton from
washer.
DO NOT REMOVE SHIPPING
ROD AT THISTIME.
Remove styrofoam
block.
Remove the bag containing
the Washer hoses and parts
parts from tub. Put styrofoam
block back in tub opening to
hold tub in place during the
rest of installation.
Hove washer close to final
position. Make sure there is
at least a 24" clearance on
right sideof washer to remove
shipping bar. PULLSHIPPING
BAR OUT USING YELLOW
PLASTIC HANDLE. K eep bar so
it can be reinstalled if washer
is ever moved again.
Styrofoam BlocJ_
Washer hoses
and parts
II
I
Shipping
Bar
Yellow plastic handle
4
NEW HOME OR REMODELING FAUCETS/
DRAI N STAN DPIPEIELECTRICAL LOCATION
Right side of
Laundry Center.
..................
_|
Locate spigots,
"
drain standpipe
ss"
|
and electrical plug
|
1
in this area
!
FLOOR
[] ELECTRICAL CON N ECTION IN FORMATION
A WAR N I N G -TOREDUCE THE RISK OF
FIRE, ELECTRICALSHOCK AND PERSONAL INJURY:
• DO NOT USE AN EXTENSION CORD OR AN
ADAPTER PLUG WITH THIS APPLIANCE.
This dryer must be electrically grounded in accordance
with local codes,or in the absence of local codes, with the
National ElectricalCode,ANSI/NFPANO. 70 or Canadian
ElectricalCode, CSAC22.1.
ELECTRICAL REQUIREMENTS
This appliance
must be connected
to an individual
branch circuit, protected
by the required time-delay
fuses or circuit breakers. A four or three-wire, single
phase, 120/240V or 120/208V, 60Hz, 30 amp circuit
is required. If the electric supply does not meet the
above specifications,
then call a licensed electrician.
GROUNDING
INSTRUCTIONS
a.
For a grounded, cord-connected appliance:
This appliance must be grounded. In the event of
malfunction or breakdown, grounding will reduce
the risk of electric shock by providing a path of
least resistance of electric current. This appliance is
equipped with a cord having an equipment-grounding
conductor and a grounding plug. The plug must be
plugged into an appropriate outlet that is properly
installed and grounded in accordance with all local
codes and ordinances.
WARNING
-Improper
connection
of the
equipment-grounding
conductor
can result
in a risk
of electric
shock.
Check with
e qualified
electrician
or servicemen
if you are in doubt
us to whether
the
appliance
is properly
grounded.
Advertisement
