Makita 9741 Instruction Manual page 5

Removing
or
installing wheel
CAUTION :
Always be sure that the tool is switched off and unplugged before removing or installing
the wheel.
To remove the wheel, insert one hex
wrench into the end of the spindle and
another hex wrench into the end of the
output shaft. Turn the hex wrench in the
output shaft clockwise while securely hold-
ing the hex wrench in the spindle
so
that
the wheel cannot revolve. Pull the output
shaft out from the wheel. Move the wheel
slightly away from the spindle and remove
the wheel from the tool.
CAUTION: The output shaft has a left hand thread.
To install the wheel, follow the removal
procedures in reverse. When installing
it,
be sure to align the notches in the wheel
with the pins on the spindle.
Adjusting front roller
The front roller allows you to apply uni-
form pressure to the workpiece. To adjust
the front roller,
set
the tool on
a
flat sur-
face and loosen the wing nut. Adjust the
front roller up or down until the clearance
distance (D) is about
2
mm (5/64").Tighten
the wing nut securely.
\
Front roller
5