Table of Contents
Advertisement
1
2
1. Rubber pad
2. Wool bonnet
3. Lock nut
1
1. Lock nut wrench
2. Wrench
OPERATION
Installing or removing the wool bonnet
003464
Mount the rubber pad onto the spindle. Screw the lock nut
onto the spindle.
3
To tighten the lock nut, hold the spindle with the wrench so
003465
that it cannot revolve, then use the lock nut wrench and
securely tighten clockwise.
2
Fit the wool bonnet completely over the rubber pad and pull
003466
the string tight. Tie a bow knot and tuck the knot and any
loose strings between the wool bonnet and the rubber pad.
To remove the wool bonnet, follow the installation procedure
in reverse.
Polishing operation
003477
CAUTION:
•
Always wear safety glasses or a face shield during
operation.
Hold the tool firmly. Turn the tool on and then apply the wool
15
bonnet to the workpiece.
In general, keep the wool bonnet at an angle of about 15
degrees to the workpiece surface.
Apply slight pressure only. Excessive pressure will result in
poor performance and premature wear to wool bonnet.
7
Advertisement
Table of Contents
