Table of Contents
Advertisement
Using the SETUP utility
Warnings
1. Selecting the wrong drive type may result in losing capacity, or,
2. It is recommended that the first time you power up your XEN-
For dual drive systems unless both drives are the same you must
know the drive type of at least one drive. Select the correct drive
type for one drive, then use any of the methods given earlier to
configure the second drive correctly.
System
The system automatically detects the total amount of onboard
Memory
memory and sets the corresponding value in the SETUP program.
The three system memory parameters are displayed for
information only and are not user adjustable.
Math
The system automatically detects the presence of a coprocessor
Coprocessor
and sets the corresponding value in the SETUP program. This
parameter is displayed for information only and is not user
adjustable.
Video display
The system automatically detects the video mode of your
primary display and sets the corresponding value in the SETUP
program. This parameter is displayed for information only and
is not user adjustable.
Serial port 1
These parameters allow you to set the baud rate, parity, stop
settings
bit and data length for serial port 1.
Use the up and down arrow keys to select the parameter you
want to change, then use the left and right arrow keys to scroll
through the possible values until you reach the correct one.
The default values for the port are 9600 baud, odd parity, 1
stop bit and 7 bit data.
Memory Test
The system performs a RAM test during Power On Self Test
(POST). Setting this parameter to disable bypasses the RAM test.
Fixed Disk
This option can enhance fixed disk drive performance, depending
Block Mode
on the fixed disk used in the system.
6/8 XEN-PC OWNER'S HANDBOOK
if drive is already formatted, data.
PC you invoke SETUP and make a note of the drive type parameters.
This will ensure that you can always reconfigure the drive type
correctly.
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
