Maintenance; Replacing Carbon Brushes - Makita RD1100 Instruction Manual

1
2
3
4
1. Router bit
2. Base
3. Templet
4. Workpiece
5. Templet guide
6. Lock nut

MAINTENANCE

1. Limit mark
1. Brush holder cap
2. Screwdriver
12
Secure the templet to the workpiece. Place the tool on the
003696
6
templet and move the tool with the templet guide sliding
along the side of the templet.
5
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.

Replacing carbon brushes

001145
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
1
Use a screwdriver to remove the brush holder caps. Take out
003703
the worn carbon brushes, insert the new ones and secure
the brush holder caps.
1
2
To maintain product SAFETY and RELIABILITY, repairs, any
other maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always using
Makita replacement parts.