Makita HR2000 Instruction Manual page 6

Switch action
Tool speed is increased by increasing pres-
sure on the trigger. To start the tool, simply
pull the trigger. Release the trigger to stop.
For continuous operation, pull the trigger
and then push in the lock button. To stop
the tool from the locked position, pull the
trigger fully, then release it. A speed con-
trol screw is provided
so
that maximum
tool speed can be limited (variable). Turn
the speed control screw clockwise for
higher speed, and counterclockwise for
lower speed.
Higher _Lower
Speed control screw
Lock button
CAUTION:
Before plugging in the tool, always check to
see
that the trigger switch actuates properly
and returns to the "OFF" position when released.
Reversing switch action
This tool has
a
reversing switch to change
the direction of rotation. Move the revers-
ing switch lever to the
&>
position for
clockwise rotation or the
4%)
position for
counterclockwise.
CAUTION :
*Always check the direction of rotation
before dril I ing.
*Use the reversing switch only when the
tool comes to a complete stop. Changing
the direction of rotation before the tool
stops may ruin the tool.
Torque limiter
The torque limiter will actuate when
a
certain torque level
is
reached. The motor will
disengage from the output shaft. When this happens, the bit will stop turning.
CAUTION :
*As soon
as
the torque limiter actuates, switch o f f the tool immediately. This will help
prevent premature wear of the tool.
0
Hole saws, core bits, diamond core bits, etc. cannot be used with this tool. They tend
to pinch or catch easily in the hole. This will cause the torque limiter to actuate too
frequently
.
6