Makita 1051D Instruction Manual page 5

Specific Safety Rules
US604
1
-
1
1.
Be aware that this tool is always in an operating condition, because it does
2. Rags, cloth, cord, string and the like should never be left around the work
3. Avoid cutting nails. Inspect for and remove all nails from the workpiece before
4. Use only sharp blades. Handle the blades very carefully.
5.
Be sure the blade installation bolts are securely tightened before operation.
6. Hold the tool firmly w i t h both hands.
7. Keep hands away from rotating parts.
8. Before using the tool o n an actual workpiece, let
it
run for a while. Watch
for vibration or wobbling that could indicate poor installation or a poorly
balanced blade.
9. Make sure the blade is not contacting the workpiece before the switch is
turned on.
not have t o be plugged into an electrical outlet.
area.
operation.
IO. Wait
until
the blade attains full speed before cutting.
11. Keep at least
200 mm (8")
away from the tool at all times.
12. Always switch off and wait for the blades t o come
to
a complete stop before
13.
Never stick your finger into the chip chute. Chute may jam when cutting damp
14. Do not leave the tool running. Operate the tool only when hand-held.
15. When leaving the planer, switch off and set it
w i t h the front base up o n a
16. Always change both blades or covers on the drum, otherwise the resulting
17.
Wait for complete run-down before putting the tool aside.
18.
Use only Makita blades specified in this manual.
any adjusting.
wood. Clean out chips w i t h a stick.
wooden block, so that the blades do not contact anything.
imbalance will cause vibration and shorten tool life.
SAVE THESE INSTRUCTIONS.
5