Makita 1002BA Instruction Manual page 6

Adjusting depth of cut
Depth
of
cut may be adjusted by simply
turning the knob on the front
of
the tool.
Adjusting front base
The front base is factory-adjusted to allow
concave cuts with a radius of 320
mm. For
concave cuts with the tool's minimum
radius of 300 mm, loosen the wing bolt on
either side and raise the front base as far
as it will go. Then retighten the two wing
bolts firmly to secure the front base.
Switch action
To start the tool, simply pull the trigger.
Release the trigger to stop. For continuous
operation, pull the trigger and then push in
the lock button. To stop the tool from the
locked position, pull the trigger fully, then
release it.
Knob
1
Wing bolt
CAUTION:
Before plugging in the tool, always check to see that the switch trigger actuates properly
and returns to the "OFF" position when released.
6