Loading Nailer; Adjusting Depth Of Nailing - Makita AG090, AG125 Instruction Manual

Nail shank
Nail tip
Magnet
Nail
Nail guide
Adjuster
Air fitting
Air socket
12

Loading nailer

CAUTION:
• Be careful not to touch the trigger when loading the nail.
Nail head
• When loading nail into the nailer, grip the nail by the
shank, not the tip.
Hold the nail shank lightly and insert the nail head into the
nail guide until the nail is held firmly by the magnet.
Contact arm

Adjusting depth of nailing

CAUTION:
• Always disconnect the hose before adjusting the depth
of nailing.
To adjust the depth of nailing, turn the adjuster so that the
arrow above the adjuster will point to the number indicated
on the adjuster. The depth of nailing is the deepest when the
arrow points to the number 1. It will become shallower as the
arrow points to higher number. The depth can be changed in
approx. 1.5 mm (1/16") increments per graduation. If nails
cannot be driven deep enough even when the arrow points to
the number 1, increase the air pressure.
Connecting air hose
Slip the air socket of the air hose onto the air fitting on the
nailer. Be sure that the air socket locks firmly into position
when installed onto the air fitting. A hose coupling must be
installed on or near the tool in such a way that the pressure
reservoir will discharge at the time the air supply coupling is
disconnected.