Advertisement
Operation
Hold the tool firmly. Turn the tool on and
then apply the wheel or disc to the work-
piece.
In general, keep the edge of the wheel or
disc a t an angle of about
15"
to the work-
piece surface.
During the break-in period with a new
wheel, do not work the grinder in the B
direction or it will cut into the workpiece.
Once the edge of the wheel has been
rounded off
by
use, the wheel may be
worked in both A and B directions.
WARN
I
NG :
0
It should never be necessary to force the tool. The weight of the tool applies adequate
pressure. Forcing and excessive pressure could cause dangerous wheel breakage.
.Continued use of a worn-out wheel may result in wheel explosion and serious personal
injury. Depressed center wheel should not be used after it has been worn down to
115
mm (4-1/2") in diameter. Use of the wheel after this point is unsafe and it should
be removed from service and rendered unusable by intentional destruction.
MAINTENANCE
CAUTION :
Always be sure that the tool is switched off and unplugged before attempting to perform
inspection or maintenance.
To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and
replacement, any other maintenance or adjustment should be performed by Makita
Authorized of Factory Service Centers, always using Makita replacement parts.
7
Advertisement
