Maintenance - Makita 6013B Instruction Manual

Drilling in wood
In drilling holes in wood using
a
wood drill with
a
guide screw, there
is
no need to bear
down on the tool. The guide screw makes it bore naturally by itself.
In general, use a cutting lubricant when drilling metal. (But not with iron or brass).
0
Drilling in metal
Switch action
"Model 60138:
To start the tool, simply pull the trigger.
Release the trigger to stop. For continu-
ous operation without having to keep
your finger on the trigger, just pull the
trigger and then push in the lock button
with your thumb. To stop the tool from
the lock position, simply pull the trigger
again and release
it.
*Model 601 3BR,
The switch
i s
reversible, providing either
clockwise or counterclockwise rotation.
Pulling the lower part of the trigger puts
the wrench on in the clockwise direction.
Pulling the upper part of the trigger puts
the tool on in the counterclockwise direc-
tion. Simply releasing either end
of
the
trigger turns the tool off.
Warning: It
i s
dangerous and injurious to the tool to reverse the rotation by rapid
switching without waiting for the motor to stop. Put the tool off, then wait
for complete stop before switching direction of rotation.
MAINTENANCE
Carbon brushes
Replace carbon brushes when they wear
down to about 5 mm (3/16") or sparking
will occur. Both brushes should
be
changed at the same time.
5