Configuring Ldp Igp Synchronization: Ospf - Cisco ASR 9000 Series Configuration Manual

Implementing MPLS Label Distribution Protocol
Command or Action
session protection for peer_acl_1
duration 60
Step 4 Use the commit or end command.
Related Topics
Session Protection, on page 15
Configuring LDP Session Protection: Example, on page 55

Configuring LDP IGP Synchronization: OSPF

Perform this task to configure LDP IGP Synchronization under OSPF.
By default, there is no synchronization between LDP and IGPs.
Note
SUMMARY STEPS
1. configure
2. router ospf process-name
3. Use one of the following commands:
4. Use the commit or end command.
OL-28381-02
• mpls ldp sync
• area area-id mpls ldp sync
• area area-id interface name mpls ldp sync
Cisco ASR 9000 Series Aggregation Services Router MPLS Configuration Guide, Release 4.3.x
Configuring LDP IGP Synchronization: OSPF
Purpose
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
39