Makita Sander Manual page 8

ASSEMBLY
1. Lock nut
2. Abrasive disc
3. Rubber pad
1
2
1. Lock nut wrench
2. Shaft lock
8
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing side grip (handle)
001059
CAUTION:
• Always be sure that the side grip is installed securely
before operation.
Screw the side grip securely on the position of the tool as
shown in the figure.
Installing or removing abrasive disc
001114
(optional accessory)
1
2
NOTE:
3
• Use sander accessories specified in this manual. These
must be purchased separately.
Mount the rubber pad onto the spindle. Fit the disc on the
rubber pad and screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft lock firmly so that the
001621
spindle cannot revolve, then use the lock nut wrench and
securely tighten clockwise.
To remove the disc, follow the installation procedure in
reverse.
IF USED AS A GRINDER
NOTE:
• Use grinder accessories specified in this manual. These
must be purchased by separate.
WARNING:
• Always use guard assembly or accessory kit, noted
below, for type 27 depressed center grinding wheel/
Multi-disc.